Differences

This shows you the differences between two versions of the page.

--- networking:cisco:passwd_recovery [2016/02/19 07:20] – rplecko
+++ networking:cisco:passwd_recovery [2018/01/27 11:25] (current) – rplecko
@@ Line 1: / Line 1: @@
-===Cisco IOS Password recovery for 2900XL, 3500XL, 2940, 2950, 2960, 2970, 3550, 3560, and 3750 series switches===
+=== Cisco IOS Password recovery for 2900XL, 3500XL, 2940, 2950, 2960, 2970, 3550, 3560, and 3750 series switches ===
-{{downloads:pswdrec_2900xl.pdf|Password recovery PDF}}
+{{:downloads:pswdrec_2900xl.pdf|Password recovery PDF}}
 Power the switch and bring it to switch: prompt
-switch: flash_init
+switch: flash_init \\
-switch: load_helper
+switch: load_helper \\
-switch: dir flash:
+switch: dir flash: \\
-switch: rename flash:config.text flash:config.old
+switch: rename flash:config.text flash:config.old \\
-switch: boot
+switch: boot \\
-After booting the switch
-enable
-rename flash:config.old flash:config.text
-Sw1# conf t
+After booting the switch enable rename flash:config.old flash:config.text
-!−−− To overwrite existing secret password
-Sw1(config)# enable secret
-<new_secret_password>
+Sw1# conf t !−−− To overwrite existing secret password Sw1(config)# enable secret
-!−−− To overwrite existing enable password
+<new_secret_password> !−−− To overwrite existing enable password
 Sw1(config)# enable password <new_enable_password>
-!−−− To overwrite existing vty password
+!−−− To overwrite existing vty password Sw1(config)# line vty 0 15 Sw1(config−line)# password <new_vty_password> Sw1(config−line)# login !−−− To overwrite existing console password Sw1(config−line)# line con 0 Sw1(config−line)# password <new_console_password>
-Sw1(config)#
-line vty 0 15
-Sw1(config−line)#
-password <new_vty_password>
-Sw1(config−line)# login
-!−−− To overwrite existing console password
-Sw1(config−line)# line con 0
-Sw1(config−line)# password <new_console_password>
-Write the running configuration to the configuration file with the  write memory command.
+Write the running configuration to the configuration file with the write memory command.
-Sw1#
+Sw1# write memory Building configuration… [OK] Sw1
-write memory
-Building configuration...
-[OK]
-Sw1